Reset Inverted Channels; Pan And Tilt Encoder - GLP SCAN OPERATOR FX User Manual

6. Repeat the steps 3 to 5, in order to configure further fixtures.
Important:
7. The changes are not automatically stored but they are directly active. Therefore
it is necessary that you confirm the changes for durable storing once with the
RECORD or the SETUP key.
8. Press the SETUP key for 3 seconds, to leave the Setup mode again.

3.13.2 Reset inverted Channels

In order to set all inverted channels back, proceed as follows:
1. Activate Setup mode (SETUP key).
2. Now select "Invert" in the menu of Setup mode
3. Press the DELETE key.
For confirmation you will receive the message "Invert RESET".
Important:
4. The changes are not automatically durably stored but they are directly active.
Therefore it is necessary that you confirm the changes for durable storing once
with the RECORD or the SETUP key.
5. Press the SETUP key for 3 seconds, to leave the Setup mode again.

3.14 Pan and Tilt Encoder

You can assign the Pan/Tilt Encoder wheels for each Fixture to one of the 16 DMX
of channels in each case. They serve as additional input mode for Pan and Tilt
values beside the appropriate DMX faders. In addition the effect generator also
falls back to the channels adjusted here, if Pan/Tilt effects are produced.
You can make change Pan and Tilt values of different DMX fixtures, even if the
DMX channel reservation is different.
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
37