GLP SCAN OPERATOR FX User Manual page 33

1. Activate PROGRAM mode (PROGRAM key)
2. Start the effect by pressing the "FX editor" key. Now the 12 keys of the effects
section should light up.
3. Select desired lamp with their Fixture key. Several Fixtures can be selected at
the same time.
4. Now select the desired effect by pressing the appropriate effect key.
5. With the "FX Speed" and "FX Size" Faders you can change the size and speed
of an effect for the selected fixtures. Size and speed can be selected in 8
stages in each case.
6. With the keys "Offset+" and "Offset -" and/or. "Bank UP" and "Bank down" you
can increase and/or manually make a smaller starting angle ("offset") of the
selected lamps in 90° steps.
Alternatively the starting angle can be varied by means of "Create Wave" or
"Randomize" key (see above).
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
33