Reference To Copying To A Scanoperator 12 Advanced; Editing Logo; Set Back Logo - GLP SCAN OPERATOR FX User Manual

3.24 Reference to copying to a Scanoperator 12 Advanced

Since the Scanoperator 12 Advanced does not have any DMX Input, you need a
special adaptor cable (DMX to Midi) for copying. This cable can be acquired
separately. You can also manufacture it if necessary (see User Manual of the
Scanoperator 12 Advanced).
Note that after copying the inverted channels of the Scanoperator FX will also be
inverted at the Scanoperator 12 Advanced. These cannot however later be
changed. Therefore it is advisable to set these back before copying.
A deletion of the entire memory of a Scanoperator 12 Advanced deletes any
existing inverted channels.
Same applies to effects provided with the Scanoperator FX. These will also run on
a Scanoperator 12/PT Advanced , but can not be edited there.

3.25 Editing logo

You can change the Logo, which is shown when switching the Unit on, according
to your own desires. In order to do this, you switch the Unit on, while you keep the
AUTO key pressed.
You can change now change the position of the cursor with the pan Encoder
wheel. You can now change the Letters with the tilt Encoder wheel..
As soon as you finished editing the text, you need to store it with the "RECORD"
key. The display shows the message "Logo Saved". Switch the Scanoperator on
and off, again.

3.26 Set back logo

In order to set the Logo back, switch on the unit while you keep the AUTO key
pressed. Now press the "DELETE" key and store thereafter with the "RECORD"
key. Restart the ScanOperator now.
Reference:
The Logo is not deleted, if you set back the entire memory !
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
53