Storing Current Playback Condition As A Autostart Condition; Calling Up Banks (Play Mode); Calling Up A Scene Manually - GLP SCAN OPERATOR FX User Manual

3.16.3 Storing current playback condition as a autostart condition

If you activate the Autostart mode, then you can store the current playback
condition as an Autostart condition. This condition is then restored when switching
on the Scanoperator.
The following parts are stored as Autostart condition:
• The chosen bank and the current active scene
• Possible running chasers and their position
• Possible active overlays
• The source of beats (manual, auto or music) and their adjustments (auto
speed or music sensitivity )
• The adjusted Fadetime
To store the current condition, keep the RECORD key pressed while pressing the
TAPSYNC key. The display shows „Autostrt Saved".
Caution:
Please, note that the Autostart mode must have been activated before in Setup
menu. If this should not be the case and you try to store the current playback
condition as an Autostart condition, there will be a reference on the display saying
"Autostrt disabled".

3.17 Calling up banks (Play mode)

3.17.1 Calling up a scene manually

1. After turning the CONTROLLER on it is automatically in the Play mode.
2. Make sure that the announcement for the manual clock shines (on the right of
the display).
3. Use the BANK UP/DOWN keys to call up the bank with the desired scenes.
4. Call up the desired scene with the scenes keys.
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
41