Using Pan And Tilt Encoder Wheel; Desklock Function; Autostart Function; Activating Autostart Function - GLP SCAN OPERATOR FX User Manual

3.14.2 Using Pan and Tilt Encoder wheel

You can use the pan and Tilt Encoder of wheels both in the Program and in the
Play mode. The Encoder wheels change the accordingly configured Pan/Tilt DMX
channels in each case.
The Fine key regulates if, whether per click on the Pan/Tilt wheels, either to 1
DMX step (Fine on) or 8 DMX steps (Fine out) are made.

3.15 Desklock function

The CONTROLLER offers a Desklock function, which can close the user interface
for further inputs. You activate and/or deactivate the Desklock by pressing the
PAGE SELECT key while you are already keeping the PROGRAM and SETUP
key pressed together.
While the Desklock is active, all user inputs at the equipment are ignored. The
Midi entrance is not affected by the Desklock, so that during an activated Desklock
the Playbacks of the desk are further able to be controlled with the remote.
By simply switching the set on and off, the Desklock is deactivated as well. If you
want the Desklock to be activated automatically when switching on the unit, please
read the following chapter about "Autostart function".

3.16 Autostart function

The Scanoperator FX offers an Autostart function, which repairs the stored
playback condition by switching the set on and off. In addition the possibility exists
that when switching the set on, the Desklock is activated automatically.

3.16.1 Activating Autostart function

In order to activate the Autostart mode, you proceed as follows:
1. Activate Setup mode (SETUP key)
2. Now select "Autostart" in the menu of Setup mode (shortened by "Autostrt").
3. Now use the Pan Encoder, in order to activate and/or deactivate the Autostart
function.
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
39