Delete Chasers; Delete All Chasers - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX
1. Activate PROGRAM Mode (PROGRAM key).
2. Select the desired Chaser which contains the step that should be deleted.
3. Press the TAPSYNC key. The last step of the Chaser is now indicated in the
LCD display
4. Press the BANK UP/DOWN key to change to the Chaserstep which should be
deleted.
5. Press the DELETE key to delete the indicated Chaserstep. As memory
confirmation you will receive the message "step deleted".
Reference:
The steps, which lie behind the deleted step, all slip a step forward now and the
new step at the deleted position is now being loaded. Therefore pressing the DEL
key 3 times , deletes 3 steps starting after the current Position

3.7.5 Delete Chasers

You can likewise delete a whole Chaser. Afterwards the chaser does not contain
any steps.
1. Activate PROGRAM Mode (PROGRAM key).
2. Keep the DELETE key pressed. Additionally press the appropriate Chaser
key.
3. As delete confirmation you will receive the message "Chaser Deleted".

3.7.6 Delete all Chasers

.
1. Keep the two keys Bank UP and Bank DOWN pressed in the switched off
condition of the set
2. Switch on the CONTROLLER again. All Chasers are now deleted.
3. As confirmation you will receive the message "Chasers Deleted".
24
(V1.3)
GLP German Light Products