Activate Programming; Programming Scenes; Creating A New Scene - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX
• „Autostart" to configure the Autostart options
In Easy Mode the second line is blank.
Besides that the display also shows a short confirmation or an error report. These
overwrite the current informations of the display for a few seconds. Afterwards the
display turns back to its normal condition. Examples fur such short reports are „Memory
Reset", „Scene Saved", „Midi Set / Keyboard", „Fader xy / Value abc" ...
3.5

Activate programming

After turning the unit on you are in PLAY Mode.
By pressing the Program key for 3 seconds you change to program mode. Here
scenes, effects and chasers can be created and the Blackout functions as well as
the Overlay scenes can be configured. After pressing the program key again for 3
seconds, you return to play mode.
3.6

Programming scenes

3.6.1 Creating a new Scene

A scene is an adjustment of all 192 DMX values of different DMX sets including a
possible Pan/Tilt effect for each fixture. Up to 240 scenes can be stored. The
scenes are subdivided in 30 banks with each 8 scenes.
16
(V1.3)
GLP German Light Products