Configuring Pan And Tilt Encoder Wheel - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX
So Pan/Tilt can be on the channels 1/2 on set 1 and on channel 5/6 on set 2. By
using the Pan/Tilt Encoder wheels you can access the Pan/Tilt of both devices.
After a deletion of the entire memory, channels 1 and 2 are assigned to the
Pan/Tilt wheels for each Fixture.

3.14.1 Configuring Pan and Tilt Encoder wheel

In order to assign to the Pan and Tilt Encoders to a channel, you proceed as
follows:
1. Activate the Setup mode (SETUP key).
2. Now select "Pan" or "Tilt" in the menu of the Setup mode
3. Select desired fixtures with appropriate fixture keys. Several fixtures can be
selected at the same time for treatment.
4. Use the scenes keys, in order to assign a pan and/or Tilt channel to the
selected Fixtures of the current channel. In the display the respective channel
is then confirmed with "Channel pan XY" or "Channel Tilt XY".
5. If necessary you press the PAGE key, in order to be able to change the further
8 DMX channels (channels 9-16).
6. Repeat the steps 2 to 5, in order to configure further fixtures.
Important:
7. The changes are not automatically durably stored but they are directly active.
Therefore it is necessary that you confirm the changes for durable storing once
with the RECORD or the SETUP key.
8. Press the SETUP key for 3 seconds, to leave the Setup mode again.
38
(V1.3)
GLP German Light Products