Configuring Fade Time Function; Configuring Fade Channels - GLP SCAN OPERATOR FX II User Manual

4.12

Configuring Fade time function

As already described above, it is possible to define channels that are able to "crossfade"
with the time given by the Fade time fader. The controller generates intermediate steps,
which automatically slow the movement down.
It is meaningful thereby that these intermediate steps are only to be generated for
movement and possible Dimmer channels. Therefore this configuration option offers
you the possibility of defining in which channels the Fadetime has to work and in which
it does not.

4.12.1 Configuring Fade Channels

To change the Fade time of channels you proceed as follows:
1. Activate SETUP mode (SETUP key).
2. Now select "Fadetime" in the setup mode menu. You can change the Fade
Time channels now.
3. Select desired fixtures with appropriate Fixture key. Multiple fixtures can be
selected at the same time.
4. Use the scenes keys, in order to switch the channels on or off. In the
display the respective condition is shown by "Channel XY: On" or "Channel
XY : Off". "On" means that the Fade time function for this channel is activated
on the selected fixtures.
5. If necessary press the PAGE key, in order to be able to change the further
8 DMX channels (channels 9-16).
6. Repeat the steps 3 to 5, in order to configure further fixtures.
Important:
The changes are not automatically durably stored but they are directly active.
Therefore it is necessary that you confirm the changes for durable storing
once with the RECORD or the SETUP key.
7. Press the SETUP key for 3 seconds to leave the Setup mode again.
35/57