Switching Between Modes; Lcd Display Informations - GLP SCAN OPERATOR FX User Manual

In easy mode as well as in play mode,192 DMX channels are being sent. The channels
1-120 can be, as written above, controlled by the user. The channels 121-192 will be
constantly transferred with value „0".

Switching between Modes

3.3
To activate the different modes, press the belonging key for 3 seconds:
• Program mode: PROGRAM key
• Setup mode: SETUP key
• Easy mode: PROGRAM+SETUP key simultaneous
Switching between all modes can be done by pressing the belonging key. The Play
mode can be reached by pressing the key, which brought you into the current mode
again for 3 seconds.
Example:
If you are in setup mode and want to change to program mode, press the program key
for 3 seconds.
If you are in program mode and want to go back to play mode, just press the program
key again for 3 seconds.

LCD Display informations

3.4
The LCD display consists of 2 lines of each 8 signs. The display is intensivly used to
show the current condition. In a normal condition it always shows the current mode in
the first line. In the line below you can find informations to the belonging mode.
In Play Mode you have the current bank and the current scene shown in the second
line. If a chaser is activated, it will be shown at the end oft he first line.
In Program mode you can also see the current bank and scene in second line. Besides
that there is a extra „Overlay Bank" that should be marked with „Overlay".
In Setup Mode you can see the belonging menu point in second line, which you can
configure now. The following menu points can be chosen:
• "Midi" to configure the MIDI channel and MIDI assignment
• "Invert" to reverse channels
• "Fadetime" to configure Fadetime channels
• "Tilt" to configure the Tilt Encoder wheel
• "Pan" to configure the Pan Encoder wheel
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
15