Insert A Bank Into A Chaser - GLP SCAN OPERATOR FX User Manual

3.7.1 Insert a step into a Chaser
With this function you can insert a scene, which is loaded, straight into a Chaser (behind
the current step of the Chasers).
.
1. Activate PROGRAM mode (PROGRAM Key).
2. Press the Chaser key that you would like to program a Chaser to. Only one
Chaser can be programmed at a time.
Reference:
If you switch on a Chaser that is already containing steps in the Program mode,
then this jumps automatically to the last step of its programming. Inserting takes
place at the end of the Chasers.
3. Load one of the scenes that you stored to one of the banks before, by pressing
the appropriate scene key.
4. Press the RECORD key.
5. As confirmation of inserting the display shows the message "Scene Inserted".
6. Repeat the steps 3 and 4 to arrange the desired program. You can store a
maximum of 250 steps in a Chaser.
7. If a Chaser has reached the maximum number of steps, the display shows the
message "Chaser Full".
3.7.2

Insert a bank into a chaser

You might copy a whole bank into a Chaser as well. In this case the controller will insert
all existing scenes on that bank into the chaser automatically (If the chaser is containing
steps already, it will insert the steps at the end). If the bank is empty, then nothing is
inserted.
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
21