Editing Scenes; Copying A Scene - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX

3.6.2 Editing scenes

1. Activate PROGRAM mode (PROGRAM key).
2. Press BANK UP/DOWN key to call up the desired bank in which the scene,
that shall be edited is on.
3. Load desired scene by pressing the appropriate scenes key. Now you can
change and store again, as in the case of creating.
Caution:
Loading a scene that is not containing any values is not possible! In that case you
receive the error message "Scene Empty".
4. Make the desired changes with the Faders. Select the appropriate Fixtures, for
that, previously.
5. After you made the changes you press the RECORD key.
6. Press the previously selected scenes key again, to store the changes. You will
receive the message "Scene Saved".
Reference:
Of course the now changed scene can be stored in another scene or even on a
different bank. Therefore it is possible to quickly create the appropriate scenes for
chases, where each step of the chase should be based on the same scene, but a
little different.

3.6.3 Copying a scene

1. Activate PROGRAM mode (PROGRAM key).
2. Press the BANK UP/DOWN key to call up the desired bank in which the scene
that shall be copied is on.
3. Load the scene which you would like to copy by pressing the appropriate
scene key once.
Caution:
Loading an empty scene is not possible! In that case you receive the error
message "Scene Empty".
18
(V1.3)
GLP German Light Products