Changing And Storing Fade Time Channels - GLP SCAN OPERATOR FX User Manual

Changing and storing Fade Time channels

3.12.1
To change the Fade time of channels you proceed as follows:
1. Activate SETUP mode (SETUP key).
2. Now select "Fadetime" in the setup mode menu. You can change the Fade
Time channels now.
3. Select desired fixtures with appropriate Fixture key. Multiple fixtures can be
selected at the same time.
4. Use the scenes keys, in order to switch the channels on or off. In the display
the respective condition is shown by "Channel xy: On" or "Channel xy : Off".
"On" means that the Fade time function for this channel is activated on the
selected fixtures.
5. If necessary press the PAGE key, in order to be able to change the further 8
DMX channels (channels 9-16).
6. Repeat the steps 3 to 5, in order to configure further fixtures.
Important:
7. The changes are not automatically durably stored but they are directly active.
Therefore it is necessary that you confirm the changes for durable storing once
with the RECORD or the SETUP key.
8. Press the SETUP key for 3 seconds to leave the Setup mode again.
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
35