Connecting To The Unit; Ethernet Port; Modem Port - LEGRAND Server Technology PRO1 User Manual

Connecting to the Unit

Serial (RS232) port
The PRO1 Sentry Switched DC PDU is equipped with an RJ45 Serial RS-232 port for attachment to a PC or
networked terminal server using the supplied RJ45 to RJ45 crossover cable and RJ45 to DB9F serial port
adapter as required.

Ethernet port

The PRO1 Sentry Switched DC PDU is equipped with an RJ45 10/100Base-T Ethernet port for attachment to
an existing network. This connection allows access to the unit via Telnet or Web.
The DC PDU is also configured with the following network defaults to allow unit configuration out-of-the-box
through either Telnet or Web:
Note: When installed on a DHCP enabled networks, the following network defaults do not apply because the
PRO1 Sentry Switched DC PDU ships with DHCP support enabled.
•
IP address:
•
Subnet Mask: 255.255.255.0
•
Gateway:
The local PC network connection must be configured as noted below:
Note: For instructions about reconfiguring the network connection, contact your system administrator. A
restart may be required for the reconfiguration of your network to take effect.
•
IP address:
•
Subnet Mask: 255.255.255.

Modem port

The DC PDU Manager is equipped with a DB9 male modem serial port for connection to an external modem
using the supplied DB9 female to DB25 male serial cable.
192.168.1.254
192.168.1.1
192.168.1.x (where x is 2-253)
Sentry Switched DC PDU
37 of 211