LEGRAND Server Technology PRO1 User Manual page 108

Network > SNMP
The SNMP page provides the network protocol and agent configuration settings for SNMP support.
About Concurrent Sessions:
SNMP does not use sessions; therefore, multiple simultaneous manager operations are supported.
About SNMP Versions:
•
The firmware supports SNMP v1, v2c, and v3.
•
SNMP version 3 supports authentication and encryption on a per user basis. Authentication types are
None and MD5. Encryption types are None and DES. If you use authentication, you must use encryption.
•
Up to eight SNMPv3 users are supported. For each SNMPv3 user you can set access as read only, write
only, read/write, or disabled. All eight users have the same configuration parameters, and you can
configure each user independently.
•
SNMPv2c and SNMPv3 can be enabled or disabled independently. You can have SNMPv2 and/or SNMPv3,
or none.
To Configure the SNMP v2 Agent:
1. Check (or uncheck) the Enable checkbox to enable/disable SNMP v2 Agent support.
2. GET community (RO): Community strings for GET commands.
3. SET community (RW): Community strings for SET commands.
4. Click Apply.
Note: The default for SNMP support is Enabled. When Server Technology products are shipped, the default
SNMP configuration for the GET community string is set to "public" and the SET community string is left
blank.
PRO1 Sentry Switched DC PDU
108 of 211