Appendix E: Regulatory Compliance
Product Safety
Units have been safety tested and certified to the following standards:
•
USA/Canada UL 60950-1:2007 R10.14 and CAN/CSA 22.2 No. 60950-1-07 +A1+A2
•
European Union EN 60950-1:2006 + A11 +A1 + A12 + A2
This product is also designed for Norwegian IT power system with phase-to phase voltage 230V.
Notifications
USA Notification
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at the user's own expense.
Modifications not expressly approved by the manufacturer could void the user's authority to operate the
equipment under FCC rules.
Canadian Notification
This Class A digital apparatus complies meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigencies du Règlement sur le matériel brouilleur du
Canada.
European Union Notification
WARNING: This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment
may cause radio interference.
Products with CE Marking comply with the EMC Directive (2014/30/EU), Low Voltage Directive (2014/35/EU) and
RoHS 2 Directive (2011/65/EU) issued by the Commission of the European Community.
Compliance with the following harmonized standards demonstrate conformity with the EMC and Low Voltage
Directives.
• EN 55032
• EN 55024
• EN 60950-1
PRO1 Sentry Switched DC PDU
208 of 211
Need help?
Do you have a question about the Server Technology PRO1 and is the answer not in the manual?