Epygi Quadro2x Administrator's Manual page 105

Quadro2x Manual II: Administrator's Guide
Parameter
Line Settings
FXO Settings
ISDN Settings
Gain Control Settings
Call Routing
RADIUS Settings
Voice Mail Common Settings
Dial Timeouts
IPSec, PPTP and L2TP
Dynamic DNS
Quadro2x, Quadro2xi; SW Version 4.0.x
System Default Value
Onboard Lines Configuration:
CallerID- Standard 2 FSK for all lines
Ringer type: Type A for all lines
Busy Tone and Power Disconnect indications: disabled for all lines
Off-hook caller ID - disabled for all lines
IP Lines Configuration:
1-16 IP Lines exist, attached to extensions 13 to 28. IP Lines 1 to 4 are enabled,
others are disabled.
FXS Lines Loopback Settings – Loopback is disabled for all FXS lines, Loopback
timeout is 30.
FXO line – enabled, incoming and outgoing calls allowed and routed to 00 Attendant
on both, Use FXO lines of the other device – disabled.
ISDN Trunks - Trunk 0 exists
Settings for the Trunk:
State – started,
Interface – User,
Coding Type - a-law,
Loopback mode - no loopback,
Passive Mode – disabled,
Signaling settings for the Trunk:
DID Service – disabled,
TEI Mode – Automat, TEI Assignment on Power up – enabled,
MSN Settings - No other devices connected to ISDN bus,
Route Incoming Call to - 00,
Use Default outgoing MSN – enabled,
Default outgoing MSN – undefined,
Excessive Ack. delay T200 – 4000,
Idle timer T203 – 10000,
T302 timer – 4000
T309 timer – 0,
T310 timer – 60000,
After Guard Timeout -150,
Switch type - basic_dss1,
Channel Selection – preferred,
Bearer Establishment Procedure - on progress indication with in-band
information,
Called Party Type of Number – unknown,
Calling Party Type of Number – unknown,
Called Party Numbering Plan – ISDN/telephony numbering plan,
Calling Party Numbering Plan – ISDN/telephony numbering plan,
Incoming Called Digits Size – 0,
Generate Progress Tone to IP – disabled,
Enable CLIR Service – disabled,
Alternative Disconnection Mode – enabled,
B1 and B2 channels – enabled.
FXS lines:
Transmit Gain: - 6
Receive Gain: 0
FXO lines:
Transmit Gain: 0
Receive Gain: 6
ISDN Trunks:
Transmit Gain: 0
Receive Gain: 0
Route all incoming SIP calls to Call Routing - disabled
Local Routing table - 5 entries for FXO Quadros and 4 entries for ISDN Quadros.
Entries are defined for IP, PBX and PSTN calls establishment.
Local AAA Table - no entries.
RADIUS client - disabled
Voice Mail Recording - G729a
4 seconds
No connections
Disabled
Appendix: System Default Values
105