Larson Davis SoundAdvisor 831C Reference Manual page 117

FIGURE 15-1 Timed Stop Mode
SoundAdvisor Model 831C
c.
Select a Trigger Source and Trigger Level (dB) for the alert. The
Trigger Level cannot be less than 0.1 (dB).
TAKE NOTE
LAeq, LCeq, LZeq, Lmax, Lmin, and all 6 values of Ln. If the current dB level is
greater than the Trigger Level (dB) of the selected Trigger Source at any time
during the current measurement interval, the 831C sends an alert notification
via email or text when the interval ends.
d.
Select any additional settings on the Setup Manager tabs. For more
information, see 6.2.2 Customizing Setup Values On the Setup
Manager Tabs.
e.
Press Close (
f.
Set it as the Active setup file.
g.
Go to System Properties
setting. In Timed Stop mode, the meter will store data after the
measurement according to this setting. For more information, see 8.1
Setting Data File Storage Preferences.
h.
Make a measurement.
Selecting Continuous Mode With Measurement History
a.
Select a Daily Auto-Store interval. At the end of the Auto-Store
interval, the 831C saves the measurement record to a new,
incrementally-named, data file throughout the day based on the Time
(hh:mm:ss). Time is the time of day you want to begin auto-storing
measurement records.
If you want to store a measurement record each hour of the day beginning at
TRY THIS
10:05, choose the following settings:
•
•
Setting Up a Measurement With Measurement History
93
Trigger Sources for this alert include the following statistics:
/*/
) and save your Setup.

Auto-Store: 1 hr
Time (hh:mm:ss): 10:05:00
The measurement setup shown here
makes 1 measurement history record
that last 20 seconds.
If you want to
notifications for
using this Setup, see 15.1.1 "Setting
Alert Notifications
Measurement History" on page 15-
6.
Preferences and verify the Auto-Store
enable alert
measurements
for
15-3