AUMA ACE C 01.2 Profinet Series Manual page 68

Appendix
ID Type Parameters
PRM 188 enum Event filter for Events
PRM 4846 BOOL Long-term recording
Table 85: Asset Management > Characteristics
ID Type Parameters
Data length = 62 bytes
PRM 3191 S20 Tag torque-position 1
PRM 3192 S20 Tag torque-position 2
PRM 3193 S20 Tag torque-position 3
PRM 5232 S20 No.TorqueCurvesOpen
68
Access Default Setting value
R 93223 0: ER signals
1: Warnings
2: Fault
3: Not ready REMOTE
4: ER device status
5: Configuration warning
6: Out of specification
7: Function check
8: Maintenance required
9: Failure
10: Configuration error
11: Hydraulics error
12: Wrong oper. com-
mand
13: Internal error
14: Internal warning
15: Fieldbus status
16: Hydraulics warning
17: Failure (Cfg)
18: Fault (Cfg)
19: Warnings (Cfg)
20: Not ready REMOTE
(Cfg)
21: Config. error RE-
MOTE
22: Collective signal 23
23: SIL status
24: Collective signal 25
25: Collective signal 26
26: Collective signal 27
27: Collective signal 28
28: FOC status
29: ER service 1
30: ER service 2
31: ER service 3
R 0 0: Function not active
1 Function active
Access Default Setting value
R/W _ REF 1 _
R/W _ REF 2 _
R/W _ REF 3 _
R/W 0 Min = 0
Max = 65535
Actuator controls
AC 01.2/ACExC 01.2 Profinet
Explanation
The event filter for Events is
used to define which collective
signals are to be recorded into
the event report. As soon as the
memory is full, the oldest events
are overwritten.
Long-term recording on the SD
card
Explanation
Tag for torque-position charac-
teristic 1
Tag for torque-position charac-
teristic 2
Tag for torque-position charac-
teristic 3