AUMA ACE C 01.2 Profinet Series Manual page 54

Appendix
ID Type Parameters
PRM 2556 U16 Travel diff. dx
PRM 3629 U16 Delay time
Table 59: Customer settings > Oper. time monitoring
ID Type Parameters
Data length = 4 bytes
PRM 2546 enum Operation mode
PRM 2547 MMSS01 Perm.op. time, manual
Table 60: Customer settings > Reaction monitoring
ID Type Parameters
Data length = 4 bytes
PRM 3157 enum Actuator behaviour
PRM 3158 U16 Reaction time
Table 61: Customer settings > Interlock
ID Type Parameters
Data length = 8 bytes
PRM 3218 enum Oper. mode Interlock
PRM 3219 enum Running dir. Interlock
54
Ac- Default Setting value
cess
R/W 10 Min = 10 [0.1 %]
Max = 100 [0.1 %]
R/W 6000 Min = 1 [0.001 s]
Max = 65535 [0.001 s]
Ac- Default Setting value
cess
R/W 0 0: Off
1: Manual
R/W 9000 Min = 0 [0.1 s]
Max = 36000 [0.1 s]
Ac- Default Setting value
cess
R/W 0 0: No cut-off
1: Cut-off
R/W 150 Min = 50 [0.1 s]
Max = 3000 [0.1 s]
Ac- Default Setting value
cess
R/W 3 1: Remote
2: Local
3: Remote and Local
R/W 3 1: OPEN
2: CLOSE
3: OPEN and CLOSE
Actuator controls
AC 01.2/ACExC 01.2 Profinet
Explanation
Setting the travel difference dt
The delay time defines the time
interval after terminating manual
operation until reset of the signal
'Handwheel operation'.
Explanation
Operation mode of operating
time monitoring. The actuator
operating time can be made in
'Manual' operation mode.
Perm.op. time, manual
Explanation
Type of actuator behaviour in
case no reaction is detected at
output drive during reaction
time. A warning (no cut-off) or a
fault (cut-off) is issued.
Reaction time
Explanation
Operation mode of interlock
function
Running direction in which the
interlock function is active