AUMA ACE C 01.2 Profinet Series Manual page 53

Actuator controls
AC 01.2/ACExC 01.2 Profinet
ID Type Parameters
PRM 5 U16 Start stepping OPEN
PRM 6 U16 End stepping OPEN
Table 57: Customer settings > Duty type monitoring
ID Type Parameters
Data length = 6 bytes
PRM 2121 enum Duty type monitoring
PRM 2122 U16 Perm. run time
PRM 2123 U16 Permissible starts
Table 58: Customer settings > Motion detector
ID Type Parameters
Data length = 12 bytes
PRM 2554 enum Motion detector
PRM 2555 MMSS01 Detect. time dt
Ac- Default Setting value
cess
R/W 0 Min = 0 [0.1 %]
Max = 999 [0.1 %]
R/W 1000 Min = 1 [0.1 %]
Max = 1000 [0.1 %]
Ac- Default Setting value
cess
R/W 0 0: Function not active
1: Function active
R/W 15 Min = 10 [min]
Max = 60 [min]
R/W 1200 Min = 1
Max = 1800
Ac- Default Setting value
cess
R/W 1 0: Function not active
1: Function active
R/W 50 Min = 10 [0.1 s]
Max = 1800 [0.1 s]
Appendix
Explanation
Setting the start of stepping
mode in direction OPEN
Setting the end of stepping
mode in direction OPEN
Explanation
Activate/deactivate duty type
monitoring
Excess of the permissible run
time within the last hour is mon-
itored. A warning is issued when
exceeding the permissible run-
ning time/h.
Excess of the permissible starts
within the last hour is monitored.
A warning is issued when ex-
ceeding the permissible starts.
Explanation
With active motion detection the
verification is made whether the
actuator position changes due
to the manual operation within
the detection time dt by the
travel difference dx. Con-
sequently, a mechanical move-
ment can be detected at output
drive (signal: 'Handwheel opera-
tion')
Setting the detection time dt
53