AUMA ACE C 01.2 Profinet Series Manual page 55

Actuator controls
AC 01.2/ACExC 01.2 Profinet
ID Type Parameters
PRM 4407 enum Interlock source
Table 62: Customer settings > PVST
ID Type Parameters
Data length = 18 bytes
PRM 4288 enum PVST operation mode
PRM 4195 enum PVST behaviour
PRM 4193 U16 PVST stroke
PRM 4194 MMSS01 PVST monitoring
PRM 4287 MMSS01 PVST operating time
PRM 4286 MMSS01 PVST reversing time
PRM 4292 enum PVST reminder
PRM 4289 U16 PVST reminder period
PRM 4944 enum PVST source
Table 63: Device configuration > Local controls
ID Type Parameters
Data length = 22 bytes
PRM 160 enum Indication light 1 (left)
PRM 557 enum Indication light 2
PRM 561 enum Indication light 3
PRM 565 enum Indication light 4
PRM 569 enum Indicat. light 5 (right)
Ac- Default Setting value
cess
R/W 3 1 : Interface
2 : Fieldbus
3 : Active comm. source
Ac- Default Setting value
cess
R/W 0 0: Stroke
1: End position test
R/W 1 0: OPEN
1: CLOSE
R/W 100 Min = 0 [0.1 %]
Max = 1000 [0.1 %]
R/W 600 Min = 10 [0.1 s]
Max = 3000 [0.1 s]
R/W 20 Min = 1 [0.1 s]
Max = 600 [0.1 s]
R/W 20 Min = 1 [0.1 s]
Max = 600 [0.1 s]
R/W 0 0: Function not active
1: Function active
R/W 0 Min = 0
Max = 65535
R/W 0 0: Active interface
1: I/O interface
2: Fieldbus interface
Access Default Setting value
R/W 370
R/W 269
R/W 270
R/W 268
R/W 369
Appendix
Explanation
Source of interlock function
Explanation
Setting the operation mode
PVST: Stroke = stroke-con-
trolled PVST; based on travel
across a defined stroke (stroke
PVST) within a given time
(PVST monitoring time); can be
started in any valve position
(even outside the end position)
End position test = PVST based
on test when leaving the end
position within a defined time
(PVST travel time); Can only be
started from an end position
PVST (Partial Valve Stroke
Test) behaviour
PVST (Partial Valve Stroke
Test) stroke
PVST (Partial Valve Stroke
Test) monitoring time
PVST (Partial Valve Stroke
Test) operating time
Waiting time during PVST prior
to returning to initial position.
When function is active, a mes-
sage is generated if no PVST
can be executed during remind-
er period.
Reminder period of PVST func-
tion. Generates message if no
PVST was executed during this
reminder period.
Source for PVST command
Explanation
Signal assignment for indication
light 1 (left) on the local controls
Signal assignment for indication
light 2 on the local controls
Signal assignment for indication
light 3 on the local controls
Signal assignment for indication
light 4 on the local controls
Signal assignment for indication
light 5 (right) on the local con-
trols
55