Diagnostic - AUMA ACE C 01.2 Profinet Series Manual

Actuator controls
AC 01.2/ACExC 01.2 Profinet
5. Operation via push button
of the local controls pos-
sible?
6.2.

Diagnostic

Table 39: Information on Profinet
Indication on display
Vendor ID M1834
Ident code M1821
Vendor name M1822
Profinet device type M1953
Profinet dev. name M1856
IP address M1841
Subnet mask M1849
Gateway M1850
MAC address module M1851
MAC address port 1 M1852
MAC address port 2 M1853
FW version module M1865
Channel 1 DataEx M1808
Channel 1 activity M1809
Channel 2 activity M1860
Network status M1818
Module status M1854
Config. error module M1855
Fieldbus mod. not avail. M1859
Yes
No
Various Profinet interface states can be checked via the menu Diagnostic M0022.
The <Information on Profinet> table shows the menus for the Profinet interface.
Value and description
Manufacturer ID
Ident code
Manufacturer name
Profinet device type
Profinet device name
IP address
Subnet mask
Gateway
MAC address of Profinet module
MAC address of Profinet port 1
MAC address of Profinet port 2
Firmware version of Profinet module
Device is currently used to exchange data (DataEx)
and valid data received by I/O controller
Activity of communication interface on channel/port 1 available data blocks are detected
Activity of communication interface on channel/port 2 available data blocks are detected
Network status
Status of Profinet module or Profinet connection
Configuration error of module
The Profinet module is not available
Causes and remedies
Possible causes and remedies:
I/O controller does not issue an operation command
I/O controller sends wrong operation command.
→ Check program of DCS
Possible causes and remedies:
Faults such as torque, thermal or internal fault
→ Check logic board, motor control and motor.
Corrective action
connection to I/O controller active
41