AUMA ACE C 01.2 Profinet Series Manual page 60

Appendix
ID Type Parameters
PRM 4135 enum RTC battery test
PRM 3517 U16 Vibration alarm level
Table 70: Device configuration > Service interface
ID Type Parameters
Data length = 22 bytes
PRM 1165 S20 Device tag
PRM 2175 enum Service op. mode
Table 71: Device configuration > Service functions
ID Type Parameters
Data length = 4 bytes
PRM 3486 I16 Create factory settings
PRM 3487 I16 Reset factory settings
Table 72: General information
ID Type Parameters
Data length = 48 bytes
PZD 268 BOOL Torque fault OPEN
PZD 269 BOOL Torque fault CLOSE
PZD 112 enum Selector switch
PZD 2 U16 Actual position
PZD 545 U16 Torque
PZD 120 enum Operation mode
60
Ac- Default Setting value
cess
R 1 0: Function not active
1: Function active
R 1000 Min = 500 [0.001 g]
Max = 4000 [0.001 g]
Ac- Default Setting value
cess
R/W _DEVICE-
TAG_
R/W 0 0: Control: LOCAL
1: Control: LOC+REM
Access Default Setting value
R -1 Min = 32768
Max = 32767
R/W -1 Min = 32768
Max = 32767
Access Default Setting value
R Min = 0
Max = 1
R Min = 0
Max = 1
R 1: Local
2: Off
3: Remote
R Min = 0 [0.1 %]
Max = 1000 [0.1 %]
R Min = 0 [0.1 %]
Max = 1000 [0.1 %]
R 0: Power Off
1: EMCY stop
2: Off
3: Service
4: Local
5: Interlock
6: EMERGENCY
7: Remote
8: Remote II
9: Fieldbus
10: Disabled
Actuator controls
AC 01.2/ACExC 01.2 Profinet
Explanation
RTC battery monitoring
Limit value (at sensor) for trigger-
ing the acceleration alarm
Explanation
Information for actuator identific-
ation within the plant (e.g. KKS
designation - Power Plant Clas-
sification system)
Settings for service operation
mode. Allows actuator control
via remote operation of service
interface depending on opera-
tion modes LOCAL or REMOTE.
Explanation
Creates new factory settings by
adopting the current settings
Reset current settings to factory
settings
Explanation
Torque fault OPEN active
Torque fault CLOSE active
Selector switch
Actual position
Torque
Operation mode