AUMA ACE C 01.2 Profinet Series Manual page 2

Table of contents
Read operation instructions first.
Observe safety instructions.
Purpose of the document:
This document contains information for the commissioning staff of the distributed control system and DCS software
engineers. This document is intended to support actuator integration into the DCS via the communication interface.
Reference documents:
Operation instructions (Assembly, operation, commissioning) for actuator
Manual (Operation and setting) AC 01.2 actuator controls Profinet
Reference documents can be downloaded from the Internet (www.auma.com) or ordered directly from AUMA
(refer to <Addresses>).
Table of contents
1. Safety instructions.................................................................................................................
1.1. Basic information on safety
1.2. Range of application
1.3. Warnings and notes
1.4. References and symbols
2. General information on Profinet...........................................................................................
2.1. Basic characteristics
2.2. Profinet basic functions
2.3. Communication technology
2.4. Bus access
2.5. Topology
2.6. Profinet communication cable
2.7. Profinet conformance classes
2.8. Supported functionality
2.9. Protective functions
2.10. Device types
3. Commissioning......................................................................................................................
3.1. Introduction
3.2. Profinet addressing
3.3. Configuration of Profinet interface
3.4. Communication start
3.5. Communication monitoring
3.5.1. Communication monitoring of Profinet communication
3.5.2. Communication status
3.6. I & M functions
4. Description of the data interface..........................................................................................
4.1. Input data (process representation input)
4.1.1. Process representation input (default process representation)
4.1.2. Description of the bytes in the process representation input
4.2. Output data (process representation output)
4.2.1. Process representation output arrangement
4.2.2. Description of the output data
4.3. Profinet services
4.4. Redundancy
2
Profinet device network configuration
device name assignment
signals
Actuator controls
AC 01.2/ACExC 01.2 Profinet
Page
4
4
4
5
5
6
6
7
7
7
7
9
10
11
11
11
12
12
12
13
13
13
13
13
14
15
15
15
17
30
30
32
37
37