AUMA ACE C 01.2 Profinet Series Manual page 11

Actuator controls
AC 01.2/ACExC 01.2 Profinet
2.8. Supported functionality
Switch functionality:
Device functionality
Unsupported functions
2.9. Protective functions
2.10. Device types
Table 3:
CC-A (unsynchronised)
Basic functions for Profinet
I/O with RT communica-
tion
Standard Ethernet IEEE
802.3 switches
Cable based
Wireless data transmis-
sion possible
TCP/IP communication
(acyclic services)
Actuator controls offer the following functionality:
Two Ethernet ports 100BASE-TX with integral Ethernet switch suitable for in-
dustrial applications
Conformance class CC-C RT class 2, without application synchronisation (RT
class 3)
Managed Switch Services, SNMP ...
Autonegotiation, crossover and polarity
Profinet I/O conformance class CC-B(PA) RT class 1
DCP and DHCP for IP address assignment
Web server for network configuration and diagnostic
Acyclic communication: Diagnostic & parametrisation via FDI package
Support of two simultaneous cyclic communication relations
Extended device identification in compliance with I&M 1-3
Profinet I/O version 2.3.2
GSDML version 2.3.2
Redundancy according to MRP
Redundancy according to MRRT or MRPD
Shared input and shared device
Response monitoring (watchdog)
Access protection for inputs/outputs (sync and freeze)
Process data exchange (DATA EX) monitoring with configurable timer interval
at controller
Adjustable failure behaviour at actuator
I/O controller: e.g. central automation devices like PLC
I/O supervisor: e.g. programming devices or projecting devices (PC)
I/O device: devices with binary or analogue inputs/outputs,e.g. actuators, ball
and plug valves
Network components: e.g. switches, access points, router
CC-B (unsynchronised), CC-
A plus
Certified Profinet Switches
Network diagnostic via IT
mechanisms (SNMP)
Simple device replace-
ment
Neighbourhood topology
detection (LLDP with
LLDP-MIB)
Offline topology configura-
tion possible
Optional media redund-
ancy CC-B (PA)
ring topology supported
General information on Profinet
CC-C (synchronised commu-
nication IRT) CC-B plus
Hardware supported band-
width utilisation (IRT com-
munication)
Synchronisation
Basis for time synchronised
applications (cycle times
>1ms, jitter <1µs)
11