AUMA ACE C 01.2 Profinet Series Manual page 29

Actuator controls
AC 01.2/ACExC 01.2 Profinet
Table 25: Byte 29: Function check 1
Bit Designation
(process representation)
0 Local STOP
1 Sel. sw. not REMOTE
2 Service active
3 Handwheel active
4 EMCY stop active
5 PVST active
6 —
7 —
Table 26: Byte 31: Status fieldbus
Bit Designation
(process representation)
0 Channel 1 active
1 Channel 2 active
2 Channel 1 DataEx
3 Channel 2 DataEx
4 Ch.1 FailState Fieldb.
5 Ch.2 FailState Fieldb.
6 Channel 1 activity
7 Channel 2 activity
Prm-Text-Def GSD file
Local STOP
Selector switch not RE-
MOTE
Service active
Handwheel active
EMERGENCY stop active
PVST active
—
—
Byte 30: Function check 2
The contents are reserved for further Function check signals in accordance with
NAMUR recommendation NE 107.
Byte 31: Status fieldbus
Information on the status of the Profinet interface
Prm-Text-Def GSD file
Channel 1 active
Channel 2 active
Channel 1 DataEx
Channel 2 DataEx
Channel 1 FailSafe Field-
bus
Channel 2 FailSafe Field-
bus
Channel 1 activitiy
Channel 2 activity
Byte 32: SIL signals
Causes of the Maintenance required signal in accordance with NAMUR
recommendation NE 107.
Value Description
1 Push button STOP of local controls is operated.
0 No signal
1 Selector switch is in position Local control (LOCAL) or
0 (OFF).
0 Selector switch is in position Remote control (REMOTE).
1 Operation mode Service is active.
0 No signal
1 Manual operation is active (handwheel is engaged); op-
tional signal
0 No signal
1 Operation mode EMERGENCY stop is active (EMER-
GENCY stop button has been pressed).
0 EMERGENCY stop button not pressed (normal operation).
1 Partial Valve Stroke Test function (PVST) is active.
0 No signal
No signal (reserved)
No signal (reserved)
Value Description
1 Channel 1 is the active operation command channel.
0 No signal
1 No signal (reserved for future variants)
0 No signal
1 Channel 1 is in the data exchange state (DataEx).
0 No signal
1 No signal (reserved for future variants)
0 No signal
1 No valid network communication via channel 1 (application
does not communicate with the DCS).
0 No signal
1 No signal (reserved for future variants)
0 No signal
1 Network communication on channel/port 1
0 No signal
1 Network communication on channel/port 2
0 No signal
Description of the data interface
29