Setting The Wire Sensor - Fronius Robacta TX W Operating Instructions Manual

Setting the wire
sensor
(2) (1)
(4) (3)
Rotate the wire electrode in the
1
opening (2) of the wire sensor (1) du-
ring the entire setting process
- LED (4) comes on if the wire sen-
sor (1) detects the wire electrode
Turn the adjusting screw (3) in the re-
2
verse direction until the LED (4) goes
off
- Wire sensor is deactivated
Only turn the adjusting screw (3) until
3
the LED (4) comes on again
- Wire sensor (1) is now set at the
lowest sensitivity level
- This prevents the wire sensor from
being triggered accidentally
51