And Finally - Fronius Robacta TX W Operating Instructions Manual

And finally...

1
2
3
4
5
6
116
(4)
(1)
Insert the core bolt and inner liner into the torch body coupling
Screw torch body coupling onto drive unit - use the correct tightening torque for the
torch body coupling
Thread the wire electrode into the hosepack
Connect the compressed air line to compressed air connection "A" on the torch body
changeover station
Establish the compressed air and power supply to the torch body changeover station
Place the torch body correctly onto the torch body coupling
Clean the hole (4)
4
Re-fit the spring and control slide in the
5
hole (4)
NOTE! The spring and control
slide must drop into the hole (4)
without any resistance.
Screw the gas pin (1) into the core bolt
6
using a 5.5 mm socket wrench