Checking The Torch Body Coupling; Changing The Steel Inner Liner In The Torch Body - Fronius Robacta TX W Operating Instructions Manual

Checking the
torch body cou-
pling
-
-
Changing the
steel inner liner in
the torch body
96
(1)
Check whether there is coolant residue on the surface within the marked area (1)
- If coolant residue is found, replace the coolant stop - see "Replacing coolant
stops"
For Robacta Drive and Robacta Drive CMT hosepacks only:
check the inner liner of the core bolt for wear and damage and replace if necessary
(1)
(2)
- Check the surface within the marked
area (1) for dirt
- If dirty, clean the marked area and
eliminate the cause of the dirt
- Check the surface within the marked
area (1) for damage
- If damaged, send the entire torch
body coupling to the manufactu-
rer's service department
Remove the gas nozzle from the torch
1
body
Unscrew the contact tip (1) from the
2
torch body
Unscrew the spatter guard (2) from the
3
torch body