Aligning The Robot Programming Aid - Fronius Robacta TX W Operating Instructions Manual

Aligning the robot
programming aid
1
1
64
(5)
(5)
(3)
CAUTION! Risk of injury from razor-sharp tip of robot programming aid. do not
touch the pointed end of the robot programming aid
NOTE! Always align the robot programming aid with the torch body.
Turn the torch body (3) as required
3
Push the torch body insulation (2) as
4
far as it will go onto the torch body
(4)
- The pin (4) on the torch body insu-
lation must fit into one of the three
holes (5)
NOTE! Always tighten the oppo-
(5)
site screw.
Secure the torch body insulation by
5
tightening the four previously loosened
screws (1) using an Allen key
- Tightening torque = 1 Nm
2
2