Preparing The Torch Body With Plastic Inner Liner; Preparing The Torch Body - Fronius Robacta TX W Operating Instructions Manual

Preparing the torch body with plastic inner liner

Preparing the
torch body
54
Insert the inner liner from the original
1
(3) (1)
equipment kit of the hosepack being
used (1) as far as it will go into the torch
body
Push the cutting aid (2) as far as it will
2
go onto the inner liner
Tighten the locking screw (3) of the
3
cutting aid
Pull the inner liner (1) and cutting aid
4
(2) out of the torch body
- do not change the position of the
cutting aid on the inner liner
(2)
Cut off the inner liner at the end of the
5
(2)
cutting aid (2) using a knife
Deburr the inner liner at both ends
6