Fitting The Torch Body Coupling; Safety - Fronius Robacta TX W Operating Instructions Manual

Fitting the torch body coupling

Safety

Fitting the torch
body coupling
For Robacta Drive and Robacta Drive CMT drive units:
For Robacta hosepacks:
62
CAUTION! Risk of injury from compressed air escaping unintentionally. The torch
body changeover station must remain depressurised until all work is completed.
NOTE! When fitting the torch body coupling, the TCP moves by 50 mm (1.97 in.).
Push centre bolt (1) approx. 5 mm (0.2 in.) out of torch body coupling (2) as shown
1
Position torch body coupling (2) and inner liner onto drive unit
2
Screw torch body coupling (2) as far as possible onto drive unit by hand
3
Tighten torch body coupling (3) using installation tool (4)
4
- Tightening torque = 20 Nm
Push centre bolt (1) approx. 5 mm out of torch body coupling (2) as shown
1
Fit torch body coupling (2) without inner liner onto drive unit
2
- The inner liner must have already been properly prepared in the hosepack be-
fore the torch body coupling can be fitted onto the hosepack
Screw torch body coupling (2) as far as possible onto drive unit by hand
3
Tighten torch body coupling (3) using installation tool (4)
4
- Tightening torque = 20 Nm
(1) (2)
(3)
(4)