Removing Coolant Stops; Preparing New Coolant Stops - Fronius Robacta TX W Operating Instructions Manual

Removing cool-
ant stops
Preparing new
coolant stops
(2)
(3) (3)
(1)
Place the bit insert for coolant stops (1)
1
onto the manual torque wrench (2)
(1)
NOTE! Push the bit insert on the
manual torque wrench as far as it
will go into the coolant stops.
Unscrew coolant stops (3) from the
2
torch body coupling using the manual
torque wrench
Insert the 6 x 1.5 mm O-ring into the
1
groove (1) on the inside of the coupling
crown
111