Bolt torch body changeover station to the underly-
ing surface (foundation)
Safety
Bolting the torch
body changeover
station to the un-
derlying surface
(foundation)
(1)
(1)
CAUTION! Risk of injury from compressed air escaping unintentionally. The torch
body changeover station must remain depressurised and de-energised until in-
stallation has been completed.
NOTE! Different fixings may be required to set up the device depending on the
type of underlying surface (foundation). Fixings are therefore not included in the
scope of supply of the device. The installer is responsible for selecting the right
type of fixing.
Set up torch body changeover station
1
in a suitable location
If necessary, align the torch body ch-
2
angeover station horizontally and verti-
cally using adjustment plates
Bolt the torch body changeover station
3
bases (1) to the underlying surface
(foundation)
Once bolted down, check whether the
4
torch body changeover station is hori-
(1)
zontally and vertically aligned with the
(1)
underlying surface
41