Installing The Torch Body Changeover Station - In Conjunction With Vr 7000 / Vr 7000 Cmt; Safety; General; Preparation - Fronius Robacta TX W Operating Instructions Manual

Installing the torch body changeover station - in con-
junction with VR 7000 / VR 7000 CMT

Safety

General

Preparation

42
CAUTION! Risk of injury from compressed air escaping unintentionally. The torch
body changeover station must remain depressurised and de-energised until in-
stallation has been completed.
NOTE! For wire-feed units with the "Welding torch gas purging" option, limit the
gas purging pressure to max. 6.00 bar (87.02 psi).
(1)
Place junction valve (1) on the fitting
1
panel (2) as shown
(2)
Secure junction valve as shown using
2
the screws, washers and nuts provided