And Finally - Fronius Robacta TX W Operating Instructions Manual

(9)
(9)

And finally...

1
2
3
4
Thread the wire electrode into the hosepack
Connect the compressed air line to compressed air connection "A" on the torch body
changeover station
Establish the compressed air and power supply to the torch body changeover station
Place the torch body correctly onto the torch body coupling
Push the torch body insulation (2) as
9
far as it will go onto the torch body
- ensure that the torch body insula-
(8)
tion is in the same position on the
(2)
torch body as it was before dis-
mantling
- the pin (8) in the torch body insula-
(9)
tion must fit into one of the three
holes (9)
NOTE! Always tighten the oppo-
site screw.
Secure the torch body insulation by
10
tightening the four previously loosened
screws (1) using an Allen key
- Tightening torque = 1 Nm
119