Checking The Torch Body For Damage And Wear - Fronius Robacta TX W Operating Instructions Manual

Checking the
torch body for
damage and wear
(2)
(7)
(7)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(7)
- Check wire guide pin (1) for damage
- Check coolant pin (2) for damage
- Check gas pin (3) for damage
- If a component is damaged, send
the torch body and the entire torch
body coupling to the manufactu-
rer's service department.
- Check the TX inlet/outlet nozzle (4) for
wear and replace if necessary
- Check the O-ring (5) on the wire guide
pin for damage and replace if neces-
sary
- Check the O-ring (6) on the gas pin for
damage and replace if necessary
- Check screws (7) are securely seated
and tighten if necessary
- Tightening torque = 1 Nm
NOTE! Always tighten the oppo-
site screw.
95