Fitting New Coolant Stops; And Finally - Fronius Robacta TX W Operating Instructions Manual

Fitting new cool-
ant stops
(1)

And finally...

1
2
3
4
(2)
Thread the wire electrode into the hosepack
Connect the compressed air line to compressed air connection "A" on the torch body
changeover station
Establish the compressed air and power supply to the torch body changeover station
Place the torch body correctly onto the torch body coupling
- completed coolant stop
Carry out the steps listed above on the
7
second coolant stop
NOTE! Fit the coolant stops as far
as they will go onto the bit insert
on the manual torque wrench.
Lightly lubricate the O-ring on the coo-
1
lant stop
Fit the ready-made coolant stop onto
2
the bit insert for the coolant stop (1) on
the manual torque wrench
Insert the coolant stop into a hole (2)
3
with a rotary movement
- the rotary movement will not da-
mage the O-ring
Tighten coolant stop
4
- Tightening torque = 3 Nm
(2)
Repeat the steps listed above on the
5
second coolant stop
113