Preparing torch body with steel inner liner
Preparing the
torch body
52
Insert the inner liner from the original
1
(3)
(1)
equipment kit of the hosepack being
used (1) as far as it will go into the torch
body
Push the cutting aid (2) as far as it will
2
go onto the inner liner
Tighten the locking screw (3) of the
3
cutting aid
Pull the inner liner (1) and cutting aid
4
(2) out of the torch body
-
do not change the position of the
cutting aid on the inner liner
(2)
Cut off the inner liner at the end of the
5
cutting aid (2) using cutting pliers
(2)
Deburr the inner liner at both ends
6