Configuring Settings For Device Management Software - Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual

Configuring Settings for Device Management Software

You can facilitate the collection and management of various information about networked devices by implementing device management
software, such as iW Management Console , into the network. Information such as device settings, Address Books, and error logs is
retrieved and distributed via the server computer. If the machine is connected to such a network, the device management software
searches the network for the machine by using protocols such as Service Location Protocol (SLP) to gather information from the machine.
This section describes the procedures of the SLP settings and settings for communication between the machine and plug-ins for iW
Management Console. These settings can be specified via Remote UI.
*
For more information about iW Management Console, contact your local authorized Canon dealer.
Configuring SLP Communication with Device Management Software
Configuring Settings for iW Management Console Plug-ins
To use iW Management Console plug-ins
You need to enable dedicated setting and SNMP setting (either SNMPv1 or SNMPv3) to communicate with an iW Management
Console plug-in.
Device Settings Management On/Off
Monitoring and Controlling the Machine with SNMP
Configuring SLP Communication with Device Management Software
1
Start the Remote UI and log on in System Manager Mode.
2
Click [Settings/Registration].
3
Click [Network Settings]
*
[TCP/IP Settings].
Starting Remote UI
0SCJ-08A