Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 266

5
Specify the scan settings as necessary.
Select the settings.
6
Press .
Scanning starts.
If you want to cancel scanning, tap <Cancel>
When placing documents in the feeder in step 2
When scanning is complete, the scanned data is saved in the USB memory device.
When placing documents on the platen glass in step 2
When scanning is complete, follow the procedures below (except if you selected JPEG as a file format in step 5).
1
If there are additional pages of documents to be scanned, place the next document on the platen glass,
and press
Repeat this step until you finish scanning all of the pages.
When there is only one page to be scanned, proceed to the next step.
2
Tap <Finish>.
The scanned data is saved in the USB memory device.
How the folders to save scanned data and files are named
When scanning is complete, a folder is automatically created in the USB memory device to save the scanned data. Folders and
files are named as follows.
Folder The "SCAN_00" folder is created and up to 100 files are saved in the folder. The folders "SCAN_01" to "SCAN_99" are
Name then created when the current folder becomes full of 100 files.
File names from "SCAN0000.XXX" to "SCAN9999.XXX" are given to the scanned data files ("XXX" is the extension for
File the file format such as "JPG"). For the first two numerical digits, the same number is allotted as that of the folder
Name number in which the files are saved. For example, The fifth JPEG file stored in the "SCAN_01" folder is named
"SCAN0105.JPG".
7
Tap <Close>.
8
Disconnect the USB memory device from the USB port (USB2.0).
1
Press .
2
Press .
3
Tap <Device Status>.
Specifying Detailed Settings
<Yes>.
.