Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 338

If your wireless router is not found
Check whether the machine is properly installed and ready to connect to the network.
8
Enter the network key that you have written down.
Enter the network key using the numeric keys, and tap <Apply>.
Entering Text
WEP
9
Tap <Yes>.
If an error message is displayed during setup
Tap <Close>, check whether the network key is correct, and return to step 5.
10
Check that the Wi-Fi indicator is blinking on the operation panel.
The Wi-Fi indicator blinks when a wireless router is detected.
When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi indicator lights up.
Wait approximately 2 minutes until the IP address settings of the machine are completed.
Signal strength
When more than one wireless router is available for connection, the machine connects to the device with the strongest signal.
Signal strength is measured using RSSI (Received Signal Strength Indication).
Reducing power consumption
You can set the machine to enter <Power Save Mode> based on signals emitted from the wireless router.
Mode
WPA-PSK or WPA2-PSK
Installation/Settings Problems
Power Save