Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 600

Cannot find the access point.
When automatic setting with WPS was attempted, a wireless router could not be detected within a specific
period of time.
Connect again paying attention to the time limit.
Setting Up Connection Using WPS Push Button Mode
Setting Up Connection Using WPS PIN Code Mode
An SSID or network key of a wireless router was entered manually, but the entry was incorrect.
Check the SSID and network key, and enter the correct ones again.
Checking the SSID and Network Key
Setting Up Connection by Specifying Detailed Settings
A wireless router could not be detected due to setting problems of the network to be connected.
Check whether the machine is properly installed and ready to connect to the network.
Installation/Settings Problems
If the problem persists, check the security settings of the wireless router.
Cannot print RX data.
A received document cannot be printed due to the following:
A cover is open.
There is no paper loaded.
The paper or document is jammed.
The toner cartridges is consumed.
An error has occurred.
Check whether the problems above are occurring. If messages including causes and solutions appear on the display,
check the contents.
Cannot receive the fax. Make sure the fax was sent correctly by the sender.
The recipient's machine did not respond within 35 seconds.
Ask the sender to send the fax again. If you hear a beep, select <Start Receiving> to receive the fax.
Receiving Faxes (MF729Cx / MF728Cdw / MF628Cw)
Cannot send because more than one destination is specified.
Sending a fax to multiple destinations is disabled.
To specify multiple destinations, you need to set <Restrict Sequential Broadcast> to <Off> or <Confirm Sequential
Broadcast>. For more information, contact your Administrator.
Prohibiting Sequential Broadcasting (MF729Cx / MF728Cdw / MF628Cw)
Cannot specify a group.