Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 240

This setting allows you to specify a method of printing when the <RGB Source Profile> is applied. This machine
includes a color management system that provides the following color rendering styles.
See Matching Method for the description of the setting.
<RGB Pure Black Process>
This setting enables you to specify how black and gray data with the equivalent ratio of R to G to B should be
processed when device dependent RGB data is converted into device dependent CMYK data using the <RGB Source
Profile> of the machine.
See RGB Pure Black Process for the description of the setting.
<CMYK Pure Black Process>
This setting enables you to specify how monochrome data (C=M=Y=0) should be printed when the device dependent
CMYK data is processed using the <CMYK Simulation Profile> of the machine.
See CMYK Pure Black Process for the description of the setting..
<Composite Overprint>
You can overprint device-dependent CMYK data as composite output.
All colors used for data are overlaid and printed on one plate so you can check the finished result without separating
the colors.
See Composite Overprint for the description of the setting.
<Advanced Smoothing>
Select how jagged outlines of text and graphics are smoothed. <Smooth 2> applies a stronger smoothing effect
than <Smooth 1>. You can apply the setting separately for text and graphics.
See Advanced Smoothing for the description of the setting.
<Grayscale Conversion>
You can select ways to convert color values to a grayscale value when you print color print data.
See Grayscale Conversion for the description of the setting.
<Print Quality>
<Density>(<Density (Fine Adjust)>)
This mode is not available if you set <Toner Save> to <On>.
This setting adjusts the print density.
See Density/
<Toner Save>
Select whether to reduce toner consumption.
See Toner Save for the description of the setting.
<Special Smoothing Mode>
Select a smoothing mode to print documents with a smooth finish. If you are not satisfied with the printing results
of <Mode 1> (default), you can try printing again by using another.
See Special Smoothing Mode for the description of the setting.
<Line Control>
Select the data processing method to reproduce lines.
See Line Control for the description of the setting.
7
Press .
Printing starts.
If you want to cancel printing, tap <Cancel>
8
Disconnect the USB memory device from the USB port (USB2.0).
1
Press .
2
Press .
3
Tap <Device Status>.
4
Tap <Remove Memory Media>.
Wait until the message <The memory media can be safely removed.> is displayed.
5
Disconnect the USB memory device.
Density (Fine Adjust) for the description of the setting.
<Yes>