Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 347

3
If <Off> is selected, change the setting to <On>.
4
Tap <Apply>.
IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Check that <Auto Acquire> is set to <Off>.
If <On> is displayed, tap <Auto Acquire>, and set both <Select Protocol> and <Auto IP> to <Off>.
2
Tap <Manually Acquire>.
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
Specify the settings in the following order: <IP Address>
Enter each setting using the numeric keys, and tap <Apply>.
5
Restart the machine.
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Checking whether the settings are correct
Make sure that the Remote UI screen can be displayed with your computer (
available, you can check the connection by using the operation panel (
Testing the Network Connection
1
Tap <Menu> in the <Home> Screen.
2
Tap <Network Settings>.
If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press
Machine
3
Select <TCP/IP Settings>
4
Enter the IPv4 address of another device on the network, and tap <Apply>.
If a proper connection has been established, the result is displayed as shown above.
<IPv4 Settings> <PING Command>.
<Subnet Mask> <Gateway Address>.
Starting Remote UI). If a computer is not
Testing the Network Connection).
. Logging on to the