Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 527

*1
Set Pause Time
For example, when you make calls by dialing "0 - (pause) - (telephone number)", 0 is dialed first and then a few seconds later, the
telephone number. When sending faxes overseas, you need to specify destinations by dialing "(international access code) - (country
code) - (area code) - (fax number)" but consecutive numbers that are input without pauses may not be recognized correctly. In this
case, try adding a pause after the international access code or the fax number. If the code or the number is still not recognized
correctly, change the duration of the pause. For instructions on how to enter a pause, see step 3 on
MF728Cdw / MF628Cw).
1 to 4 to 15 (sec.)
<Menu> <Fax Settings>
<Apply>
*1
Auto Redial
Specify settings for Auto Redial, a function that automatically redials the fax number after several minutes if the first attempt fails
because the line is busy. You can specify how many times the machine redials and the interval between redials.
Off
On
Number of Times to Redial
1 to 2 to 10 (times)
Redial Interval
2 to 99 (min.)
Redial When Error Occurs
Off
On
<Menu> <Fax Settings>
<Apply>
<Number of Times to Redial >
Specifies how many times the machine redials. Tap
<Redial Interval>
Specifies the interval between redials. Tap
<Apply>.
<Redial When Error Occurs>
When set to <On>, specifies to redial when a transmission error occurs.
TX Terminal ID
Specify settings for adding the sender information, including the fax number and the name of the machine, to the fax header. The
recipient can check who sent the fax by looking at the added information.
<TX Function Settings> <Set Pause Time>
<TX Function Settings> <Auto Redial>
/ or the numeric keys to enter a number, and tap <Apply>.
/ or the numeric keys to enter a number for the interval, and tap
Sending Faxes (MF729Cx /
Specify the duration of pause
<On> Specify the settings