Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 358

[Use LPD Printing]
Select the check box to print via LPD. When not using LPD printing, clear the check box.
[Use RAW Printing]
Select the check box to print via RAW. When not using RAW printing, clear the check box.
[RX Timeout]
Set a value between 1 and 60 (minutes) as the restart wait time for data reception. If data reception does not resume
within the set time, printing is canceled.
3
Click [OK].
Configuring WSD
1
Click [Edit] in [WSD Settings].
2
Configure the settings as necessary.
[Use WSD Printing]
Select the check box to print via WSD. When not using WSD printing, clear the check box.
[Use WSD Browsing]
Select the check box to obtain information about the machine from a computer via WSD. This check box is automatically
selected when the [Use WSD Printing] check box is selected.
[Use WSD Scanning]
Available for Windows Vista/7/8, WSD scanning enables you to scan documents to a computer without installing the
scanner driver. Select the check box to scan documents via WSD. When not using WSD scanning, clear the check box.
[Use Computer Scanning]
Select the check box to use WSD scanning by operating the machine with the operation panel. This check box can only be
selected when the [Use WSD Scanning] check box is selected. To perform scanning, tap <Scan> and specify a WSD-
connected computer as a scan destination. (
[Use Multicast Discovery]
Select the check box to set the machine to reply to multicast discovery messages. If the check box is cleared, the
machine stays in sleep mode even when multicast discovery messages are flowing on the network.
Click [OK].
Scanning from the Machine).