Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 615

＃406
A scanned document could not be stored to a USB memory device due to an error.
Remove the USB memory device, and connect it again.
Scanning Documents Directly to USB Memory
Reduce the number of documents to scan.
＃408
Write failed because the memory media was removed while it was being written to.
Check that the memory media has not been removed and then write the data again.
Printing from USB Memory (USB Print)
Images could not be transferred correctly due to an error that occurred during image transfer to the memory
media.
Check the status of the memory media and try again.
Printing from USB Memory (USB Print)
The connected memory media is using an unsupported format.
Check that the memory media is using a format supported by this machine (FAT16 or FAT32).
Printing from USB Memory (USB Print)
＃701
Authentication failed because an incorrect Department ID or PIN was entered when the Department ID
Management was activated.
Enter the correct Department ID and PIN.
Continuing operating without entering a Department ID was attempted even though unknown-ID jobs
(functions that permit operations without a Department ID and PIN) were disabled in the Department ID
Management.
Enable unknown-ID jobs in System Manager Mode in Remote UI.
Blocking Jobs When Department ID Is Unknown
＃703
Data could not be written because the memory space that was allocated for images was full when sending an e-
mail/I-Fax or storing to a shared folder.
If another sending document is queued, wait for a while until it is completed, and send again.
Divide the document into multiple sections before sending.
Delete the documents that are stored in memory.
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
＃751