Canon i-SENSYS MF729Cx Important Safety Instructions And Installation Manual page 603

Checking the SSID and Network Key
Setting Up Connection by Selecting a Wireless Router
Setting Up Connection by Specifying Detailed Settings
If the problem persists even after checking the network key, check whether the machine is properly installed and ready
to connect to the network.
Installation/Settings Problems
Copying is restricted.
Copying is disabled in the Department ID Management.
Log on with a Department ID for which copying is not disabled. For the Department ID and PIN, contact your
Administrator.
Setting the Department ID Management
Correction failed.
Appropriate paper that is required for correction is not loaded in a paper drawer.
Load plain or recycled A4 or Letter size paper into the paper drawer.
Full Adjust
Adjust Copy Image
An adjustment image that is required for correction is not placed on the platen glass correctly.
Place the adjustment image on the platen glass with the print side face down and the black stripe toward the back side
of the machine.
Full Adjust
Adjust Copy Image
Paper jammed during correction.
Remove the jammed paper, and perform correction again.
Clearing Jams
The amount remaining in toner cartridges required for correction is insufficient.
Corrections require sufficient toner cartridge remaining. Replace the toner cartridge, and perform correction again.
Replacing Toner Cartridges
The transfer belt inside the machine is dirty.
Perform automatic cleaning of the transfer belt.
Transfer Belt
Could not connect using Access Point Mode.
Connection in Access Point Mode failed due to an error.
Wait a few moments and try again. If you still cannot connect, try switching the machine off briefly.
Configuring the Settings for Direct Connection (Access Point Mode) (MF729Cx / MF728Cdw / MF724Cdw /
MF628Cw)
Could not connect using the wireless LAN. Turn the main power OFF and ON, then configure the settings
again.